Quartz clocks are usually caused by problems such as no walking, stop-and-go, slow walking, etc. We all know that this problem must be the fault of the quartz clock movement inside the clock. So, how do you troubleshoot the quartz clock? In my opinion, there are four steps to troubleshoot the above problems of quartz clock movement. If you have better troubleshooting skills and methods, please share them with us.
1. First, check whether the battery is good from the external galvanic battery and connect the positive and negative terminals of the cartridge in the battery tank of quartz clock motor core well.
2. Open quartz clock movement back cover to confirm power shrapnel is cathode and coil electricity line board on whether is good, then can also remove the magnet gear with three gears, see have such gear rotating left by you.
3. Determine the quartz clock movement on whether there is sundry gear and gear shaft is not bending misalignment, and attention should be paid to the gear shaft is short of oil, no oil is a little with a little quartz clock movement special lubricating oil or you can add some threading machine, dryer (car) of lubricating oil.
4. If the wall clock quartz clock movement is installed his clock needle, must according to quartz clock movement load to select the clock needle, when confirm the clock bell needle without collision and friction, and also note when loading the second hand do not force too big quartz clock machine movement of the second shaft is bent.