The movement of the quartz clock can also be easily repaired. The damage of the quartz clock movement is usually due to the dirty internal gears and the rusty power interface of the clock movement. The following describes how to disassemble the clock movement.
1.The casing of the movement is generally not fixed with screws, and is stuck together. When disassembling, you can use a flat-blade screwdriver to gently pry all the buckles of the casing.
2.After prying open, then gently pick up the shell, being careful not to bring out the internal gears, and do not disturb the sequence.
3.Then put the gear aside and remember the direction and position of the gear.
4.After the top gear is taken out, take out the circuit board on the right side, and then wipe the power interface clean with sandpaper or paper.
5.After cleaning, you can install the clock hands and batteries to see if they are normal. If it is normal, then install it. If it is abnormal, check whether the gear is installed in place and whether the power connector is in good condition.
6.When the clock movement is tested, install it on the dial, pay attention to the hour when installing the clock hands.
